Skip to main content

Shock detection

This feature is supported by all Abeeway trackers.

Note

Overview​

The mechanical definition of a shock is a strong acceleration intensity during a short period. It can be seen as a pulse. Once a shock has been detected, a shock detection event message is sent via LoRaWAN, which will contain a measurement for the intensity of the shock. Note • The shock detection embeds a debounce timer (fixed value of 1 second) to avoid sending multiple LoRa event messages for the same shock. • The shock detection requires the high sensitivity mode (Octet 0 of motion_sensitivity must be in the range [1..99]).

The Gadd index​

From AT2 R2.4, the shock detection has been enhanced with the calculation of the GADD index. The Gadd index seeks to measure the effects of a shock on the body, and considers both the intensity of acceleration and the duration, as it was found during experiments that body damage increases with the duration of the shock and acceleration to the power 2.5. This enhancement is only available with trackers embedding the LIS2DW12 accelerometer.

Configuration​

The configuration of the shock detection is based on a single parameter called shock_detection. This parameter gives the accelerometer sensitivity used to trigger the shock events.

Shock detection message​

Upon the detection of a shock event, the tracker triggers a shock detection LoRaWAN message as follows. The first message is sent immediately with the actual acceleration values.

The next ones are delayed by two minutes. In this case the reported value will be the highest shock that occurred during this fixed period. If no shock is detected during the two minutes period, no more payload is sent.

Last updated on