Features
- Multiple operating modes
- Standby: LoRaWAN™ heartbeat only
- Motion tracking: Get the tracker position at a given cycle when motion is detected
- Permanent tracking: Get periodic tracker position irrespective of the motion
- Start/End motion tracking: Get position messages during motion start and end events
- Activity tracking: Monitor activity rate with embedded sensors.
- OFF: device stopped
- Position on demand: Receive the tracker position only when requested (very low power operating mode).
- Low frequency periodic positions: once per hour to once a day
- Configurable motion detection
- SOS support
- Shock detection
- Angle detection
- Multiple geolocation technologies:
- GPS: Precise outdoor position.
- Low power GPS (LPGPS): Get quick position outdoors and daylight indoor conditions.
- WIFI: Indoor positioning and urban area.
- BLE: Indoor positioning (with Bluetooth beacons filtering capability)
- Buzzer and LEDs (micro trackers and smart badge only)
- Reed-switch interface (compact tracker only)
- GNSS constellation selection
- Temperature monitoring
- Battery monitoring
- Embedded antennas
- LoRaWAN ™ Class A radio
- BLE connectivity
- BLE geozoning
- BLE beaconing:
- QUUPPA
- Eddystone
- IBeacon
- altBeacon
- Default and dynamic profiles
- rating for enclosures:
- Compact tracker: Waterproof enclosure (IP68); IK08
- Smart badge and micro tracker: High Pressure Water-spray resistant enclosure (IP65)
- Industrial tracker: Dust-proof and powerful water jets - (IP66)
The asset tracker V2.3 brings the following new features:
- Extended Payload for the positions,
- SOS improvement
- Accelerometer management improvement
- New status payload
- Button sequences updated and configurable
- Supports all types of beacons for beaconing mode
- Command Line Interface over BLE
To access the release notes, click Asset tracker firmware release notes.